Ukbladesforum.co.uk

Ukbladesforum.co.uk (http://ukbladesforum.co.uk/forum/index.php)
-   How To's and How Do You's (http://ukbladesforum.co.uk/forum/forumdisplay.php?f=46)
-   -   How i Handle a knife Part 2 (http://ukbladesforum.co.uk/forum/showthread.php?t=75)

Bernie Garland 20-09-2009 01:26 PM

How i Handle a knife Part 2
 
Part 2

Scale glued on to the tang

http://i146.photobucket.com/albums/r...m/100_1383.jpg

Clean of any excess off the front with a sharp stanley knife

http://i146.photobucket.com/albums/r...m/100_1384.jpg

It will then look like this

http://i146.photobucket.com/albums/r...m/100_1386.jpg

Next step is onto the bandsaw to remove the excess

http://i146.photobucket.com/albums/r...m/100_1387.jpg

Then onto the sander for a clean up all round

http://i146.photobucket.com/albums/r...m/100_1389.jpg

Then over to the pillar drill to drill the holes for the pins

http://i146.photobucket.com/albums/r...m/100_1390.jpg

You then repeat the same procedure on the other side :)

http://i146.photobucket.com/albums/r...m/100_1391.jpg

While your waiting for it to set,instead of making another roll up, prepare the other three sets of scales for the other knives;):)

http://i146.photobucket.com/albums/r...m/100_1392.jpg

http://i146.photobucket.com/albums/r...m/100_1395.jpg

When set, back to the bandsaw, cut off the excess and clean up all round on the sander

http://i146.photobucket.com/albums/r...m/100_1394.jpg

Back on to the pillar drill and drill through the other side

http://i146.photobucket.com/albums/r...m/100_1396.jpg

Your now ready for the pins

http://i146.photobucket.com/albums/r...m/100_1397.jpg

http://i146.photobucket.com/albums/r...m/100_1398.jpg

Then glue and tap the pins in

http://i146.photobucket.com/albums/r...m/100_1399.jpg

Final job back to the disc sander to clean up both faces
If you notice i ramp the scale from front to back

http://i146.photobucket.com/albums/r...m/100_1400.jpg

All done,just the final shaping

http://i146.photobucket.com/albums/r...m/100_1401.jpg

Next part 3 the final shaping, will get Max to Vid this so you can see how i do it, as its hard to explain :)

Bernie


All times are GMT. The time now is 08:53 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.